ABSTRACT
Objective:To construct the lentiviral-vector encoding human interleukin-10 protein(LV-hIL-10) and to observe the effect of LV-hIL-10 on controlling neuropathic pain via intrathecal administration in CCI rats. Methods:hIL-10 gene fragment was isolated and amplified from pCYIL-10 plasmid by PCR, and was cloned into pWPXL. The recombinant plasmid pWPXL-IL-10,envelope plasmid pMD2.G and packaging plasmid psPAX2 were cotransfected into 293T cells, LV-hIL-10 is prepared by concentrating the collected supernatant .At the same time, the empty plasmid pWPXL-GFP,pMD2.G and psPAX2 were cotransfected into 293T cells, LV-GFP is prepared for contrast.135 sheer breed pathogen-free adult male Sprague-Dawley rats divided into 9 arrays at random: CCI models 4 arrays (C0,C1,C2,C3), sham operatived rats 4 arrays (S0,S1,S2,S3) and a normal contrast array (N), each respectively intrathecal injection LV-hIL-10 (C1,S1)、LV-GFP (C2, S2),isotonic Nachloride (C3,S3) and control (no implanted catheters and no administration, C0,S0), the pain threshold of each array and the expression of mRNA and protein of IL-10 in spinal cord,pallium and hippocampus on different time were observed after intrathecal administration LV-hIL-10 in successful CCI model rats . Results:The hIL-10 gene fragment was obtained from pCYIL-10 plasmid, pWPXL-hIL-10 was recombinated successfully. the cloned gene segment was validated by DNA sequencing .High titer(2?1010)and highly purified LV-hIL-10 particles were obtained by three plasmids were cotransfected into 293T cells. The mechanical allodynia and thermal hyperalgesia were alleviated via intrathecal injection LV-hIL-10 in CCI rats. The overexpression of IL-10 were detected in spinal cord,pallium and hippocampus , especially in the spinal cord .Conclusions:The mechanical allodynia and thermal hyperalgesia can be relieved by intrathecal injection LV-hIL-10 in CCI rats.
ABSTRACT
OBJECTIVE@#To compare the anesthesia properities of hyperbaric bupivacaine with those of isobaric and hypobaric solutions when administered in the supine position undergoing hip surgery or lower limb surgery using continuous spinal anesthesia.@*METHODS@#Sixty patients( ASA I approximately III ) scheduled for hip or lower limb surgery were randomly divided into 3 groups with 20 patients in each group: Group A: 0. 375% hyperbaric bupivacaine solutions; Group B :0.375% isobaric bupivacaine solutions; and Group C: 0. 375% hypobaric bupivacaine solutions. The following variables were measured every 2 minutes during the first 30 minutes after the intrathecal injection : the onset time of sensation block, the highest plane of analgesia, the time to reach complete motor blockade, and the plane of analgesia and the extent of lower extremities' movement (modified bromage score, BMS) at different time after the administration. Meanwhile the changes of hemodynamics were recorded.@*RESULTS@#There was no statistical difference among the basic conditions ( P > 0.05). The onset time of sensation block, and the time to reach complete motor blockade, and the time receiving the highest sharp pain sensory block in Group A were significantly shorter than those in Group B and Group C ( P < 0.01 ). The plane of analgesia obtained in the hyperbaric group was significantly higher than in both the isobaric and the hypobaric groups ( P < 0.01). The mean arterial pressure(MAP) , HR in the hyperbaric group decreased significantly after the intrathecal injection( P < 0.05 ).@*CONCLUSION@#The 0.375% Isobaric bupivacaine used during contiuous spinal anesthesia in the supine position produces a suitable and a more "controllable" anesthesia, but a minimum dosage of 10 approximately 12.5 mg is required to obtain adequate anesthesic conditions with moderate hemodynamic changes and satisfying analgesia effects. Under similar conditions, 0. 375% hyperbaric bupivacaine produces major hemodynamic consequences with high cephalad spread and 0. 375% hypobaric bupivacaine has a too long onset time.